Guitar string action gauge fret slot depth

What is the nominal fret slot width? If you target is , you will not get that with a cutter If your target is , you might

Guitar string action gauge fret slot depth I use an Irwin dovetail pull saw with a bit of wood super glued to the saw to stop the cut at the correct depth The saw follows the radius of

What is the nominal fret slot width? If you target is , you will not get that with a cutter If your target is , you might

game slot gacor terbaik The laser-cut Acrylic depth stop should be adjusted to cut a slot that is just slightly deeper than the tang of the frets Fret slots which are too deep weaken

Ideally the slot should end up 1o-20% deeper than the fret tang - the small gap underneath is filled usually with superglue Good luck

fret slot width You generally only use a table saw to cut fret slots when the fretboard is still flat Then after radiusing you just use a hand fretsaw with a

When all the fret slots have been cut, they are deepened to a uniform depth of 18 Attach a strip of wood to one side of the blade using doublefaced